Stable bridge
Bridge USDT0 to and from Stable
Stable uses USDT0 as its native asset and gas token. puddli checks configured routes before preparing a transfer.
- Base ETH or USDC can route into Stable USDT0 when quoted
- Stable USDT0 can route back to Base assets
- native gas reserve protection
- provider availability checked before execution
Bridge into Stable USDT0
The prepared route starts on Base and targets Stable USDT0. A current quote must still confirm that the exact source asset, amount and destination are executable.
- Stable chain ID 988
- USDT0 selected as the destination asset
- provider availability checked for the current amount
Leave USDT0 for Stable gas
When bridging out of Stable, the same native USDT0 balance is also used for transaction gas. Do not send the full balance without accounting for the wallet estimate.
- keep a native gas reserve
- verify the direction before signing
- resume recorded transfers instead of duplicating them
Bridge in three clear steps
- Open the prefilled Base to Stable route and choose the source asset.
- Enter the amount and verify that Stable USDT0 is the destination.
- Continue only when the current route is available and the wallet details match.
Frequently asked questions
what token pays gas on Stable?
Stable uses USDT0 as its native gas token, so a source transfer should leave enough USDT0 for transaction gas.
can i bridge from Stable to chains other than Base?
puddli can request a provider route when Stable appears in live coverage, but the exact token pair and amount must quote successfully.
why is LayerZero shown on some Stable routes?
configured Base and Stable pairs can compare LayerZero with another routing provider and select a valid result.